3D Carbon Fiber Manual Shifter Trim Overlay - 2023+ Integra 6MT / 2022+ Civic 6MT
- In stock, ready to ship
- Premium 3D carbon fiber VINYL overlay — a deep, textured carbon-look vinyl film, not a hard plastic or real carbon part
- Protects a damage-prone panel — shields the factory trim from scuffs, scratches, and everyday wear while adding a carbon look
- Precision-cut to fit — made to match the factory contour for a clean, low-profile look
- Wet-install friendly — reposition with StickerFab fluid, then set with light heat for a bubble-free finish
- Made in the USA — cut to order by StickerFab in Fort Myers, FL from premium US/Euro-sourced vinyl
- Fits 2023+ Integra 6MT / 2022+ Civic 6MT — precision-cut for a clean, factory-look fit
3D Carbon Fiber Manual Shifter Trim Overlay - 2023+ Integra 6MT / 2022+ Civic 6MT
Protect a scuff-prone factory trim panel and add a deep, textured carbon look — with a premium 3D carbon fiber vinyl overlay, precision-cut to order by StickerFab in Fort Myers, FL for the 2023+ Integra 6MT / 2022+ Civic 6MT.
Just so it's clear: "3D Carbon Fiber" is our name for a premium textured vinyl film — a flexible carbon-look overlay that conforms to your trim. It is not real carbon fiber and it's not a hard replacement part. You get the rich 3D carbon look (and scuff protection) at a fraction of the cost of a hard part.
Protects a Piece That Takes a BeatingFactory soft-touch plastics and trim panels scuff and scratch far too easily. This overlay takes the abuse for you — it shields the trim underneath from everyday wear while giving it a deep, textured 3D carbon-fiber appearance. You protect the panel and upgrade the look in one step. |
Premium Vinyl, Made in the USAEach piece is cut to order from premium 3D carbon fiber vinyl — the same high-standard film we use across our overlays, sourced from US and European suppliers. It's durable, dimensionally stable, and built to last for years. Cut and shipped from our shop in Fort Myers, Florida — a real product made by real people, made to order. |
 |
Not All Materials Are Created EqualWe use premium vinyl with a repositionable permanent adhesive on an air-egress liner — forgiving to apply, dimensionally stable, and built to hold up over the long haul. |
🔧 Installation
Install in 75–85°F weather. A wet install is recommended: spray the surface and the back of the vinyl with StickerFab fluid so you can slide it into place, work out the fluid from the center outward, then set the adhesive with light heat from a hair dryer or heat gun. Work up the heat slowly — if it would burn you, it can burn the material.
For the 3D Carbon material, do not wax it. Clean with normal soap and water.
Recommended items:
FAQ
|
Is this real carbon fiber? |
Will it fit my car? |
|
Is it hard to install? |
How do I care for it? |
|
Is this made in the USA? |
Use collapsible tabs for more detailed information that will help customers make a purchasing decision.
Ex: Shipping and return policies, size guides, and other common questions.
