Fuel Door 3D Carbon Overlay - 2022 BRZ / GR86
- In stock, ready to ship
- Premium 3D carbon fiber VINYL overlay — a deep, textured carbon-look vinyl film, not a hard plastic or real carbon part
- Clean, dimensional carbon-fiber look — an easy styling upgrade that makes the piece stand out from stock
- Precision-cut to fit — made to match the factory contour for a clean, low-profile look
- Wet-install friendly — reposition with StickerFab fluid, then set with light heat for a bubble-free finish
- Made in the USA — cut to order by StickerFab in Fort Myers, FL from premium US/Euro-sourced vinyl
- Fits 2022 BRZ / GR86 — precision-cut for a clean, factory-look fit
Fuel Door 3D Carbon Overlay - 2022 BRZ / GR86
Give the 2022 BRZ / GR86 a deep, dimensional carbon-fiber look — with a premium 3D carbon fiber vinyl overlay, precision-cut to order by StickerFab in Fort Myers, FL.
Just so it's clear: "3D Carbon Fiber" is our name for a premium textured vinyl film — a flexible carbon-look overlay that conforms to your trim. It is not real carbon fiber and it's not a hard replacement part. You get the rich 3D carbon look (and added protection) at a fraction of the cost of a hard part.
A Simple Upgrade With Real PresenceA little vinyl in the right place makes the 2022 BRZ / GR86 stand out from any stock car. The 3D Carbon finish has a dimensional, woven carbon look — not a flat printed film — so the piece looks the part up close. |
Premium Vinyl, Made in the USAEach piece is cut to order from premium 3D carbon fiber vinyl — the same high-standard film we use across our overlays, sourced from US and European suppliers. It's durable, dimensionally stable, and built to last for years. Cut and shipped from our shop in Fort Myers, Florida — a real product made by real people, made to order. |
 |
Not All Materials Are Created EqualWe use premium vinyl with a repositionable permanent adhesive on an air-egress liner — forgiving to apply, dimensionally stable, and built to hold up over the long haul. |
🔧 Installation
Install in mild, 75–85°F weather. A wet install is recommended: spray the surface and the back of the vinyl with StickerFab fluid so you can slide it into place, work out the fluid from the center outward, then set the adhesive with light heat from a hair dryer or heat gun. Work up the heat slowly — if it would burn you, it can burn the material.
For the 3D Carbon material, do not wax it. Clean with normal soap and water.
Recommended items:
Installation Video
FAQ
|
Is this real carbon fiber? |
Will it fit my car? |
|
Is it hard to install? |
How do I care for it? |
|
Is this made in the USA? |
Use collapsible tabs for more detailed information that will help customers make a purchasing decision.
Ex: Shipping and return policies, size guides, and other common questions.
